Trying Out the Instrument
R&S
®
RTE
39Getting Started 1326.1026.02 ─ 08
8. Tap the "Undo" icon on the toolbar repeatedly until the trigger mode is "Auto"
and the trigger source is
"CH1".
9. Press the [SLOPE] key to toggle the trigger slope.
W
atch the waveform and the "Trigger" settings.
5.2 Acquiring Data
You can acquire data using different arithmetic methods to get envelope or aver-
age waveforms.
If you need to change only one setting during analysis, and you need to change it
often, you can reduce the dialog box to a small box that only contains the
required setting. Thus you can change the setting and see the result immediately.
1. Press the [ACQUISITION] key on the front panel, in the [HORIZONTAL] area.
2. In the "Acquisition" tab of the "Horizontal" dialog box, select the "Decimation"
type Sample.
3. Tap the "Arithmetic" button for C1 but do not change the setting.
4.
Tap the
"Minimize" icon in the upper right corner of the dialog box.
Acquiring Data
To Next Page
Loading...
