Rohde & Schwarz RTE - Page 59

Trying Out the Instrument
R&S
®
RTE
59Getting Started 1326.1026.02 ─ 08
3. To measure the spectrum on the math channel, tap the "Measurement" icon
on the toolbar
.
4. Tap the spectrum waveform.
The channel power is displayed below the FFT diagram.
5. Double-tap the spectrum waveform.
The "FFT Setup" dialog box opens.
6.
Set the "Center frequency" to 10 kHz.
The instrument adjusts the frequency span automatically.
Close the dialog box.
Performing a Basic FFT Analysis
www.allice.de
Allice Messtechnik GmbH