Getting started
R&S
®
RTE
104User Manual 1326.1032.02 ─ 20
8. Enter Waveform1 on the online keyboard.
9. Tap "ENTER" to close the online keyboard.
10. Select the file type: "*.bin".
11. Tap "Save".
The waveform data is saved to the files Waveform1.Wfm.bin and
Waveform1.bin in the selected directory.
Saving data of an acquisition series
1. Press the [FILE] key on the front panel.
2. Select "Waveform".
3. Set the export scope of the waveform:
a) Check the "Source".
b) Set "Scope" to "Full Waveform".
c) Tap "Data logging" to enable export all waveforms of a running acquisition.
d) Enter "Acq count" = 10, the number of subsequent waveforms that the instru-
ment acquires and saves.
4. Tap "Start Export" to save the waveforms to file. You can change the filename in
"Save to file".
Saving measurement results
1. Perform a measurement as described in Chapter 3.3.6.2, "Performing automatic
amplitude measurements", on page 87.
2. Press the [FILE] key on the front panel.
Trying out the instrument
To Next Page
Loading...
