Getting started
R&S
®
RTE
120User Manual 1326.1032.02 ─ 20
One-click actions Interactive actions
Show Help Cursor
Graphical Recall (load saveset) Masktest
Save Settings Histogram
Save Screenshot Measurement
Create Report Quick meas
Clear all FFT
Show Signal Bar Select
Autoset and Preset Delete
Run / Stop and Run Single Label
Find Trigger Level Update Ref Waveform
Force Trigger Save Waveform
Spectrogram (option R&S RTE-K18)
You can configure the content of the toolbar and hide the date/time display, see Chap-
ter 3.4.7.2, "Configuring the toolbar", on page 119.
The following list describes at first the default toolbar functions and then the additional
functions.
Undo
Undoes the last setting actions step by step. Some actions cannot be revoked: locking
the touchscreen with [T-SCREEN LOCK], and saving data. The undo stack is deleted
during the following actions: Reloading settings from file, and reference waveform
actions (save, load and preset with active reference waveform).
Redo
Recovers the undo steps in reverse order.
Show Help
Enables the tooltip display. A short description appears when you tap a parameter in a
dialog or result box. To open the corresponding help topic, tap the "Show Help" button
in the lower right corner of the tooltip. See also: Chapter 3.4.12, "Getting information
and help", on page 130.
Show Signal Bar
Shows and hides the signal bar.
The look and the behavior of the signal bar can be configured, see Chapter 3.4.6,
"Using the signal bar", on page 116.
Graphical Recall (load saveset)
Opens a window to select and load instrument settings that were previously stored in a
saveset. A graphical preview helps you to find the required settings.
Operating the instrument
To Next Page
Loading...
