Remote control commands
R&S
®
RTE
1244User Manual 1326.1032.02 ─ 20
MIN
The horizontal cursor is set to the crossing point of the vertical
cursor with the minimum waveform envelope.
MAX
The horizontal cursor is set to the crossing point of the vertical
cursor with the maximum waveform envelope.
*RST: MIN
Usage: Asynchronous command
CURSor<m>:X2ENvelope <EnvelopeCurve2>
If the waveform arithmetics are set to envelope curve (see CHANnel<m>[:
WAVeform<n>]:ARIThmetics on page 1114) and CURSor<m>:TRACking[:
STATe] is set to "ON", this setting defines how the second horizontal cursor is posi-
tioned.
Suffix:
<m>
.
1..*
Selects the cursor set. 2 cursor sets are available.
Parameters:
<EnvelopeCurve2> MIN | MAX
MIN
The horizontal cursor is set to the crossing point of the vertical
cursor with the minimum waveform envelope.
MAX
The horizontal cursor is set to the crossing point of the vertical
cursor with the maximum waveform envelope.
*RST: MAX
Usage: Asynchronous command
CURSor<m>:STYLe <Style>
Defines how the cursor is displayed in the diagram.
Suffix:
<m>
.
1 | 2
Selects the cursor set.
Parameters:
<Style> LINes | LRHombus | VLRHombus | RHOMbus
LINes
The cursors are displayed as lines.
LRHombus
The cursors are displayed as lines. The intersections of the cur-
sors with the waveforms are displayed by rhombus-shaped
points.
Cursor measurements
To Next Page
Loading...
