Rohde & Schwarz RTE - Page 1293

Remote control commands
R&S
®
RTE
1293User Manual 1326.1032.02 ─ 20
Suffix:
<m>
.
1..10
See "Selection of the measurement: MEASurement<m>"
on page 1249.
Usage: Event
Asynchronous command
MEASurement<m>:VERTical:CONT <ContAutoScl>
If enabled, automatic vertical scaling is performed whenever the waveform does not fit
in the diagram during the long term measurement period.
Suffix:
<m>
.
1..10
See "Selection of the measurement: MEASurement<m>"
on page 1249.
Parameters:
<ContAutoScl> ON | OFF
*RST: ON
Usage: Asynchronous command
MEASurement<m>:VERTical:AUTO
Performs an automatic scaling once so that the scaling is adapted to the current mea-
surement results. Available only for long term measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement: MEASurement<m>"
on page 1249.
Usage: Event
Asynchronous command
MEASurement<m>:VERTical:OFFSet <VerticalOffset>
Defines a vertical offset for the long term measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement: MEASurement<m>"
on page 1249.
Parameters:
<VerticalOffset> Range: -100E+12 to 100E+12
Increment: 1E-6
*RST: 0
Default unit: div
Usage: Asynchronous command
Automatic measurements