Rohde & Schwarz RTE - Page 1297

Remote control commands
R&S
®
RTE
1297User Manual 1326.1032.02 ─ 20
Parameters:
<FieldName>
MEASurement<m>:PROTocol:F2FRame:FRMFrom <FrameName>
Sets the type of start frame for the frame to frame protocol measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement: MEASurement<m>"
on page 1249.
Parameters:
<FrameName>
MEASurement<m>:PROTocol:F2FRame:FRMTo
<FrameName>
Sets the type of end frame for the frame to frame protocol measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement: MEASurement<m>"
on page 1249.
Parameters:
<FrameName>
MEASurement<m>:PROTocol:F2FRame:VALFrom <FrmFrmFromVal>
Sets the field value of the start frame for the frame to frame protocol measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement: MEASurement<m>"
on page 1249.
Parameters:
<FrmFrmFromVal>
Usage: Asynchronous command
MEASurement<m>:PROTocol:F2FRame:VALTo <FrmFrmVal>
Sets the field value of the end frame for the frame to frame protocol measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement: MEASurement<m>"
on page 1249.
Parameters:
<FrmFrmVal>
Automatic measurements