Rohde & Schwarz RTE - Page 1327

Remote control commands
R&S
®
RTE
1327User Manual 1326.1032.02 ─ 20
Suffix:
<m>
.
1..8
math waveform
Parameters:
<SupprThres> Range: -180 to 180
Increment: 0.1
*RST: 0
Default unit: dBm
Usage: Asynchronous command
CALCulate:MATH<m>:FFT:PHASe:UNWRap
<Unwrap>
If enabled, phase shifts due to a limitation of the value range are eliminated.
Suffix:
<m>
.
1..8
math waveform
Parameters:
<Unwrap> ON | OFF
*RST: OFF
Usage: Asynchronous command
CALCulate:MATH<m>:FFT:COUPled:WITH<1..8> <MathIndex>
Copies the current FFT settings of the selected math waveform (m) to the other
selected math waveform (m2), and couples the two waveforms. This can be repeated
for all math waveforms.
If any FFT setting for any of the coupled spectrums is changed, it is changed for all
coupled spectrums.
Suffix:
<m>
.
1..8
FFT waveforms to be coupled. <m>, <m2> must be active and
distinct.
Parameters:
<MathIndex> ON | OFF
*RST: OFF
Example: Prerequisite: FFt waveforms M1 and M2 are active.
CALC:MATH1:FFT:COUP:WITH2 ON
Couples the math waveforms M1 and M2.
Usage: Asynchronous command
Spectrum analysis