Rohde & Schwarz RTE - Page 1332

Remote control commands
R&S
®
RTE
1332User Manual 1326.1032.02 ─ 20
MTESt:CONDition........................................................................................................1333
MTESt:TOLerance....................................................................................................... 1334
MTESt:CTYPe.............................................................................................................1334
MTESt:FILE:NAME...................................................................................................... 1334
MTESt:FILE:SAVE....................................................................................................... 1335
MTESt:FILE:OPEN.......................................................................................................1335
MTESt:FILE:DELete.....................................................................................................1335
MTESt:ADD <MaskTestName>
Creates a new mask test definition with the specified name.
Setting parameters:
<MaskTestName> String with the name of the mask test
Example: See Chapter 18.3.3.1, "Creating a user mask", on page 1060
Usage: Setting only
Asynchronous command
MTESt:REMove <MaskTestName>
Deletes the mask test definition with the specified name.
Setting parameters:
<MaskTestName> String with the name of the mask test
Usage: Setting only
Asynchronous command
MTESt[:STATe] <MaskTestName>,<State>
MTESt[:STATe]? <MaskTestName>
Activates and deactivates the mask test. If the acquisition is running, the test starts
immediately. Otherwise, the test starts when acquisition is started.
The testing is stopped when acquisition is stopped, also due to the MTESt:
ONViolation:STOP command, or if MASK[:STATe] is set to "OFF".
The coommand needs *OPC command synchronisation.
Parameters:
<State> ON | OFF
*RST: OFF
Parameters for setting and query:
<MaskTestName> String with the name of the mask test
Example:
MTEST:STAT 'MyMask', ON; *OPC?
See Chapter 18.3.3.1, "Creating a user mask", on page 1060
Usage: Asynchronous command
Mask testing