Rohde & Schwarz RTE - Page 1406

Remote control commands
R&S
®
RTE
1406User Manual 1326.1032.02 ─ 20
EXPort:WAVeform:TIMestamps <UseTimestamps>
Exports the relative timestamps of all history waveforms to the waveform data file. The
time is written at the beginning of each waveform record.
Parameters:
<UseTimestamps> ON | OFF
*RST: OFF
Usage: Asynchronous command
EXPort:WAVeform:INCXvalues
<IncHorValues>
Includes horizontal values in the retrieved data (time or frequency values, depending
on the waveform). X and Y-values are written alternately to the file. If disabled, only Y-
values - mostly voltage values - are written. The X-values are always returned in 64 bit
real format, regardless of the defined data format.
The setting is not available for the export of raw data.
The command affects the content of export files as well as data retrieved with:
●
CHANnel<m>[:WAVeform<n>]:DATA[:VALues]?
●
CALCulate:MATH<m>:DATA[:VALues]?
●
REFCurve<m>:DATA[:VALues]?
●
DIGital<m>:DATA[:VALues]?
●
BUS<m>:PARallel:DATA[:VALues]?
●
ZVC:Z<m>:I<n>:DATA[:VALues]?
●
ZVC:Z<m>:V<n>:DATA[:VALues]?
Parameters:
<IncHorValues> ON | OFF
*RST: OFF
Example: See:
"Exporting interleaved x/y data of a single waveform to CSV file"
on page 1063
"Exporting interleaved x/y data of a zoom to CSV file"
on page 1064
Usage: Asynchronous command
EXPort:WAVeform:RAW <RawValues>
Enables the export of raw sample data, and sets the data format to integer 8 bit. In
high definition acquisition mode, the data format is integer 16 bit. Fot INT16, you can
set the byte order using the FORMat:BORDer command.
The raw format reduces the file size but changes also the precision of the values.
Currently, the setting is not available for the export of digital channel data and data of
R&S RT-ZVC channels.
Data management