Rohde & Schwarz RTE - Page 1532

Remote control commands
R&S
®
RTE
1532User Manual 1326.1032.02 ─ 20
TRIGger<m>:LIN:TYPE................................................................................................1532
TRIGger<m>:LIN:ICONdition.........................................................................................1533
TRIGger<m>:LIN:IMIN..................................................................................................1533
TRIGger<m>:LIN:IMAX.................................................................................................1533
TRIGger<m>:LIN:DCONdition....................................................................................... 1533
TRIGger<m>:LIN:DMIN................................................................................................ 1534
TRIGger<m>:LIN:DMAX............................................................................................... 1534
TRIGger<m>:LIN:BORDer............................................................................................ 1534
TRIGger<m>:LIN:DLECondition.....................................................................................1535
TRIGger<m>:LIN:DLENgth........................................................................................... 1535
TRIGger<m>:LIN:IDOR<n>:ENABle...............................................................................1535
TRIGger<m>:LIN:IDOR<n>[:VALue]...............................................................................1536
TRIGger<m>:LIN:SYERror............................................................................................1536
TRIGger<m>:LIN:IPERror.............................................................................................1536
TRIGger<m>:LIN:CHKSerror.........................................................................................1536
TRIGger<m>:LIN:ERRPattern....................................................................................... 1537
TRIGger<m>:LIN:CRCDatalen...................................................................................... 1537
TRIGger<m>:LIN:STANdard..........................................................................................1537
TRIGger<m>:LIN:TYPE <Type>
Selects the trigger type for LIN analysis.
See: "Trigger type" on page 605.
Parameters:
<Type> SYNC | ID | IDOR | IDDT | WKFR | ERRC
SYNC
Start of the frame, triggers on the stop bit of the sync field.
ID
Sets the trigger to one specific identifier or an identifier range.
To set the identifier, use TRIGger<m>:LIN:ICONdition,
TRIGger<m>:LIN:IMIN on page 1533, and TRIGger<m>:
LIN:IMAX on page 1533.
IDOR
Triggers on an OR combination with up to four identifier condi-
tions. For each identifier condition, enable it with TRIGger<m>:
LIN:IDOR<n>:ENABle and set the value with TRIGger<m>:
LIN:IDOR<n>[:VALue]
IDDT
Combination of identifier and data conditions
To set the identifier condition, use TRIGger<m>:LIN:
ICONdition, TRIGger<m>:LIN:IMIN, and TRIGger<m>:
LIN:IMAX.
To set the data condition, use TRIGger<m>:LIN:DCONdition,
TRIGger<m>:LIN:DMIN, and TRIGger<m>:LIN:DMAX.
WKFR
Wakeup frame
Protocols