Rohde & Schwarz RTE - Page 1533

Remote control commands
R&S
®
RTE
1533User Manual 1326.1032.02 ─ 20
ERRC
Error condition. Define the error types with TRIGger<m>:LIN:
CHKSerror on page 1536, TRIGger<m>:LIN:IPERror, and
TRIGger<m>:LIN:SYERror
*RST: SYNC
TRIGger<m>:LIN:ICONdition <IdOperator>
Sets the operator to set a specific identifier or an identifier range.
Parameters:
<IdOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These condition require one identifier pat-
tern to be set with TRIGger<m>:LIN:IMIN
INRange | OORange
In range / Out of range: Set the minimum and maximum value of
the range with TRIGger<m>:LIN:IMIN and TRIGger<m>:
LIN:IMAX
*RST: EQUal
TRIGger<m>:LIN:IMIN <IdPattern>
Specifies a slave identifier pattern, or sets the the start value of an identifier range.
Parameters:
<IdPattern> Numeric or string pattern, see Chapter 18.4.6, "Bit pattern
parameter", on page 1076.
TRIGger<m>:LIN:IMAX <IdPatternTo>
Sets the the end value of an identifier range if TRIGger<m>:LIN:ICONdition is set
to INRange or OORange.
Parameters:
<IdPatternTo> Numeric or string pattern, see Chapter 18.4.6, "Bit pattern
parameter", on page 1076.
TRIGger<m>:LIN:DCONdition <DataOperator>
Sets the operator to set a specific data pattern or a data pattern range.
Parameters:
<DataOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
Protocols