Rohde & Schwarz RTE - Page 1578

Remote control commands
R&S
®
RTE
1578User Manual 1326.1032.02 ─ 20
Parameters:
<IdentifierData> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:FLXRay[:SSOFrame] <SearchName>,<FrameStart>
SEARch:TRIGger:FLXRay[:SSOFrame]? <SearchName>
Enables the search for a start of frame.
Parameters:
<FrameStart> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:FLXRay:SSYMbol <SearchName>,<CheckSymbol>
SEARch:TRIGger:FLXRay:SSYMbol? <SearchName>
Enables the search for specified symbol.
Parameters:
<CheckSymbol> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:FLXRay:CENable <SearchName>,<CycleCount>
SEARch:TRIGger:FLXRay:CENable? <SearchName>
Sets the operator to define a cycle count or a cycle count range.
Parameters:
<CycleCount> OFF | ANY | EQUal | NEQual | LTHan | LETHan | GTHan |
GETHan | INRange | OORange
OFF = ANY
The cycle count is not relevant for the search condition.
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one cycle count
number to be set with SEARch:TRIGger:FLXRay:CMIN.
INRange | OORange
In range, Out of range: Set the minimum and maximum value of
the range with SEARch:TRIGger:FLXRay:CMIN and SEARch:
TRIGger:FLXRay:CMAX.
*RST:
OFF
Protocols