Rohde & Schwarz RTE - Page 1637

Remote control commands
R&S
®
RTE
1637User Manual 1326.1032.02 ─ 20
TRIGger<m>:ARINc:DATA:MAX <DataMax>
Sets the end value of a data pattern if TRIGger<m>:ARINc:DATA:CONDition is set
to INRange or OORange.
Parameters:
<DataMax>
TRIGger<m>:ARINc:ERRor:CODing <CodingError>
Enables triggering when a coding error occurs.
Parameters:
<CodingError> ON | OFF
*RST: ON
TRIGger<m>:ARINc:ERRor:PARity
<ParityError>
Enables triggering when a parity error occurs.
Parameters:
<ParityError> ON | OFF
*RST: ON
TRIGger<m>:ARINc:LABel:CONDition <LabelOperator>
Sets the condition for the label. You can define an exact label or a label range.
Parameters:
<LabelOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set withTRIGger<m>:ARINc:LABel:MIN.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range withTRIGger<m>:ARINc:LABel:MIN and
TRIGger<m>:ARINc:LABel:MAX.
*RST: EQUal
TRIGger<m>:ARINc:LABel:MIN <LabelMin>
Defines the minimum bit pattern for the label.
Parameters:
<LabelMin> Numeric or string pattern, see Chapter 18.4.6, "Bit pattern
parameter", on page 1076. The string parameter accepts the bit
value X (don't care).
Protocols