Rohde & Schwarz RTE - Page 1802

Remote control commands
R&S
®
RTE
1802User Manual 1326.1032.02 ─ 20
TRIGger<m>:USB:PMAX <PortTo>
Sets the the end value of a port number range if TRIGger<m>:USB:PCONdition is
set to INRange or OORange.
Parameters:
<PortTo>
TRIGger<m>:USB:SCONdition <OperatorSEU>
Sets the operator to set a specific SEU or an SEU range. The SEU values are set with
TRIGger<m>:USB:SMIN and TRIGger<m>:USB:SMAX.
For SEU, see "SEU" on page 834.
Parameters:
<OperatorSEU> OFF | ANY | EQUal | NEQual | LTHan | LETHan | GTHan |
GETHan | INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less than or equal, Greater than,
Greater than or equal. These conditions require one SEU value
to be set using TRIGger<m>:USB:SMIN.
INRange | OORange
In range, out of range. These conditions require a range of SEU
values to be set using TRIGger<m>:USB:SMIN and
TRIGger<m>:USB:SMAX.
*RST: OFF
TRIGger<m>:USB:SMIN <SEU>
Specifies the SEU, or sets the the start value of an SEU range.
Parameters:
<SEU>
TRIGger<m>:USB:SMAX <SEUTo>
Sets the the end value of an SEU range if TRIGger<m>:USB:SCONdition is set to
INRange or OORange.
Parameters:
<SEUTo>
TRIGger<m>:USB:SPEC <USBSpecialType>
Sets the trigger to one out of four different Special PID types: PREamble, ERR, SPLit,
or PING.
Parameters:
<USBSpecialType> PREamble | ERR | SPLit | PING
Protocols