Rohde & Schwarz RTE - Page 1890

Remote control commands
R&S
®
RTE
1890User Manual 1326.1032.02 ─ 20
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:CXPI:DATA:DMIN <SearchName>,<DataMin>
SEARch:TRIGger:CXPI:DATA:DMIN? <SearchName>
Specifies a data bit pattern, or sets the start value of a pattern range.
Parameters:
<DataMin>
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:CXPI:DATA:ICONdition <SearchName>,<DataIdxOperator>
SEARch:TRIGger:CXPI:DATA:ICONdition? <SearchName>
Set the condition for the data index value. You can define an exact value or a value
range.
Parameters:
<DataIdxOperator> EQUal | LTHan | LETHan | GTHan | GETHan | INRange |
RANGe
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one pattern to
be set with the corresponding SEARch:TRIGger:CXPI:DATA:
IMIN command.
INRange = RANGe
In range: Set the minimum and maximum value using SEARch:
TRIGger:CXPI:DATA:IMIN and SEARch:TRIGger:CXPI:
DATA:IMAX.
*RST:
INRange
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:CXPI:DATA:IMAX <SearchName>,<DataIndexMax>
SEARch:TRIGger:CXPI:DATA:IMAX? <SearchName>
Sets the end value of a data index range if SEARch:TRIGger:CXPI:DATA:
ICONdition is set to INRange or RANge.
Parameters:
<DataIndexMax> Range: 1 to 0
Increment: 1
*RST: 0
Parameters for setting and query:
<SearchName>
Protocols