Rohde & Schwarz RTE - Page 1891

Remote control commands
R&S
®
RTE
1891User Manual 1326.1032.02 ─ 20
SEARch:TRIGger:CXPI:DATA:IMIN <SearchName>,<DataIndexMin>
SEARch:TRIGger:CXPI:DATA:IMIN? <SearchName>
Specifies a data index bit pattern, or sets the start value of a pattern range.
Parameters:
<DataIndexMin> Range: 1 to 0
Increment: 1
*RST: 1
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:CXPI:DEXTension:CONDition
<SearchName>,<DLCEXTOperator>
SEARch:TRIGger:CXPI:DEXTension:CONDition? <SearchName>
Set the condition for the DLC extend value. You can define an exact value or a value
range.
Parameters:
<DLCEXTOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set with the corresponding SEARch:TRIGger:CXPI:
DEXTension:MIN command.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with SEARch:TRIGger:CXPI:DEXTension:MIN
and SEARch:TRIGger:CXPI:DEXTension:MAX.
*RST:
EQUal
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:CXPI:DEXTension:MAX <SearchName>,<DLCEXTMax>
SEARch:TRIGger:CXPI:DEXTension:MAX? <SearchName>
Sets the end value of a DLC extend range if SEARch:TRIGger:CXPI:DEXTension:
CONDition is set to INRange or OORange.
Parameters:
<DLCEXTMax>
Parameters for setting and query:
<SearchName>
Protocols