Rohde & Schwarz RTE - Page 1892

Remote control commands
R&S
®
RTE
1892User Manual 1326.1032.02 ─ 20
SEARch:TRIGger:CXPI:DEXTension:MIN <SearchName>,<DLCEXTMin>
SEARch:TRIGger:CXPI:DEXTension:MIN? <SearchName>
Specifies a data extension bit pattern, or sets the start value of a pattern range.
Parameters:
<DLCEXTMin>
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:CXPI:DLC:CONDition
<SearchName>,<DLCOperator>
SEARch:TRIGger:CXPI:DLC:CONDition? <SearchName>
Set the condition for the DLC. You can define an exact value or a value range.
Parameters:
<DLCOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one DLC pattern
to be set with the corresponding SEARch:TRIGger:CXPI:
DLC:MIN command.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with SEARch:TRIGger:CXPI:DLC:MIN and
SEARch:TRIGger:CXPI:DLC:MAX.
*RST:
EQUal
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:CXPI:DLC:MAX <SearchName>,<DLCMax>
SEARch:TRIGger:CXPI:DLC:MAX? <SearchName>
Sets the end value of a data type range if SEARch:TRIGger:CXPI:DLC:CONDition
is set to INRange or OORange.
Parameters:
<DLCMax>
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:CXPI:DLC:MIN <SearchName>,<DLCMin>
SEARch:TRIGger:CXPI:DLC:MIN? <SearchName>
Specifies a DLC pattern, or sets the start value of a pattern range.
Protocols