Rohde & Schwarz RTE - ZVC Current Settings

Acquisition and waveform setup
R&S
®
RTE
225User Manual 1326.1032.02 ─ 20
Reset Overload
Resets the overload indication at the probe.
Remote command:
ZVC:Z<m>:V<n>:OVERload:RSTO on page 1151
5.6.3 ZVC current settings
Access: "Vertical" menu > "ZVC Multi-Channel Probe" > "Setup" dialog > "Setup" of
current channel
See also:
●
Scale
●
Offset
Channel
Selects the amperemeter channel to be configured.
State
Enables the corresponding current channel of the probe. The number of available
channels depend on the characteristics of your multi-channel power probe.
Remote command:
ZVC:Z<m>:I<n>[:STATe] on page 1150
Bandwidth
Displays the bandwidth of the current channel. You can set the probe bandwidth in the
"Setup" dialog.
R&S
RT-ZVC probe