Measurements
R&S
®
RTE
359User Manual 1326.1032.02 ─ 20
Pulse count
Sets the number N of positive pulses for the "Pulse train" measurement. This measure-
ment measures the duration of N positive pulses from the rising edge of the first pulse
to the falling edge of the N-th pulse.
Remote command:
MEASurement<m>:AMPTime:PTCount on page 1263
Edges slope
Sets the edge direction to be considered. The setting is relevant for edge count mea-
surement and delay measurement on digital channels.
"Positive"
Positive edges are considered.
"Negative"
Negative edges are considered.
"Either"
Both positive and negative edges are counted (edge count). Delay is
measured either between rising edges or between falling edges. The
first edge is taken for the measurement.
Remote command:
MEASurement<m>:AMPTime:ESLope on page 1263
Delay to trigger measurement settings
Delay to trigger measures the time between the trigger point and the following slope of
a waveform. The delay between the trigger and the slope can be high compared to the
accuracy of the acquisition, and the trigger point can even be outside of the current
acquisition.
Trigger
source
Measurement
source
Trigger
level
Reference
level
Slope
Trigger
event
Delay to trigger
See also: Chapter 8.2.5.3, "Measuring the delay to trigger", on page 360.
To configure the trigger conditions, use the trigger setup. To set up the slope, additional
settings appear in the measurements "Setup" dialog box.
Automatic measurements
To Next Page
Loading...
