Rohde & Schwarz RTE - Page 423

Mask testing
R&S
®
RTE
423User Manual 1326.1032.02 ─ 20
Acq. completed
Number of tested acquisitions.
Remote command:
MTESt:RESult:COUNt:WAVeforms? on page 1349
Acq. remaining
Remaining acquisitions until "Average count / Nx Single count" is reached.
The value is useful if you test a specified number of acquisitions with action "Stop
acquisition" on violation. Also if the acquisition has been stopped manually before the
required number of acquisitions has been acquired.
See also: Chapter 10.3.4, "Running a mask test", on page 442.
Remote command:
MTESt:RESult:COUNt:REMaining? on page 1350
State
Shows if the test has been completed. The state is set to "Finished" when "Nx Single
count" acquisitions are tested and the number of "Acq. remaining" is 0. as long as the
number of tested acquisitions is less the "Nx Single count" number, the state is "Run-
ning".
If you run the acquisition with [RUN CONT], or the number of played history acquisi-
tions exceeds "Nx Single count", the mask testing is performed according to fail criteria
settings independently of the test state. The testing is not stopped when the state is set
to "Finished".
Remote command:
MTESt:RESult:STATe? on page 1349
Sample hits
Number of samples that hit the mask.
Remote command:
MTESt:RESult:COUNt:FAILures? on page 1350
Acquisition hits
Number of acquisitions that contained at least one sample hit.
Remote command:
MTESt:RESult:COUNt:FWAVeforms? on page 1350
Fail rate
Ratio of acquisition hits to the number of tested acquisitions.
About mask testing