Data and file management
R&S
®
RTE
495User Manual 1326.1032.02 ─ 20
Results to export
Selects the measurement to be exported.
Remote command:
EXPort:MEASurement:SELect on page 1410
Export type
You can export the result data of the long-term measurement, the measurement histo-
gram or the track. To export the data, the required type must be enabled in "Measure-
ments > Long Term/Track": "Long term Enable", "Histogram Enable" or "Track".
Remote command:
EXPort:MEASurement:TYPE on page 1410
Incidence
Sets the mode of exported histogram data: relative or absolute count of values. If rela-
tive values are exported, the sum of all values is 1, and the count of each value is set
in relation to the sum.
Remote command:
EXPort:HISTogram:INCidence on page 1408
Measurement source, Meas scale
Show the measurement settings source and scale for information.
Save to file
Enter the filename to save the measurement data to. Double-tap the filename to open
the file selection dialog box.
By default, the filename has the prefix "Measurement_". You can define a pattern for
automatic naming in the "Autonaming" tab. The default directory is:
C:\Users\Public\Documents\Rohde-Schwarz\RTE\Measurements
"Save"
Saves the measurement data in the selected file.
"Save As..."
Opens the file selection dialog box and saves the measurement data
to the selected file. See also Chapter 12.7, "File selection dialog",
on page 511
Waveform data and results
To Next Page
Loading...
