Protocol analysis
R&S
®
RTE
537User Manual 1326.1032.02 ─ 20
SEARch:TRIGger:I2C:STCNdition on page 1444
SEARch:TRIGger:I2C:NACKnowledge on page 1444
SEARch:TRIGger:I2C:SADDress on page 1444
SEARch:TRIGger:I2C:ADOR on page 1445
SEARch:TRIGger:I2C:ADData on page 1445
Address setup: Condition, Type, Addr. min, Addr. max, R/W bit
The address setup consists of the condition, type, R/W bit and one or two address pat-
terns.
The address setup settings are the same as in the I2C trigger setup, see "Address"
on page 530.
Remote command:
SEARch:TRIGger:I2C:ACONdition on page 1445
SEARch:TRIGger:I2C:ADDRess on page 1446
SEARch:TRIGger:I2C:ADDTo on page 1446
SEARch:TRIGger:I2C:AMODe on page 1446
SEARch:TRIGger:I2C:ACCess on page 1447
Data setup: Condition, Position, Index min, Index max, Value min, Value max
The data setup consists of the condition, position, and one or two index/value patterns.
The data setup settings are the same as in the I2C trigger setup, see "Data"
on page 531.
Remote command:
SEARch:TRIGger:I2C:DPOPerator on page 1448
SEARch:TRIGger:I2C:DPOSition on page 1449
SEARch:TRIGger:I2C:DPTO on page 1449
SEARch:TRIGger:I2C:DCONdition on page 1449
SEARch:TRIGger:I2C:DMIN on page 1450
SEARch:TRIGger:I2C:DMAX on page 1450
I²C (option R&S
RTE-K1)
To Next Page
Loading...
