Protocol analysis
R&S
®
RTE
631User Manual 1326.1032.02 ─ 20
Figure 13-36: FlexRay - decode results with applied label list
Data format
You can select various data formats for the values displayed in the decode table and in
the combs of the decoded signal.
Remote command:
●
BUS<m>:FORMat on page 1422
Zooming on decoded results
The zoom functions allow you to analyze the decode results in more detail. If "Zoom
coupling" is enabled, the decode zoom and result table are synchronized; if you select
a row in the result table, this result is shown in the decode zoom.
For an introduction to zoom settings and setup, see:
●
Chapter 7.1.2, "Zoom settings", on page 280
●
Chapter 7.1.3, "Zooming for details", on page 284
Export of decode results
1. In the protocol decode table, press "Export".
FlexRay (option R&S
RTE-K4)
To Next Page
Loading...
