Rohde & Schwarz RTE - Page 633

Protocol analysis
R&S
®
RTE
633User Manual 1326.1032.02 ─ 20
Search Criteria
Sets one criterion or an AND-combination of criteria to be searched for. If more than
one criterion is selected, all criteria must be fulfilled by a frame for it to be shown in the
search results.
"Start of frame"
Searches for the first rising edge after the transmission start
sequence (TSS).
"Identifier+data"
Searches for the decoded frame content, on header and payload
data:
●
Indicator bits, see "Indicator bits" on page 633
●
Frame identifier, see "Frame ID (min/max)" on page 634
●
Payload length, see "Payload length (min/max)" on page 634
●
Cycle count, see "Cycle count (min, max), Step" on page 634
●
Data position, see "Position, Index (min, max) - Data setup"
on page 635
●
Data bit pattern, see "Condition, Data (min, max) - Data setup"
on page 635
"Symbol"
Searches for a symbol or wakeup pattern, see "Symbol"
on page 635.
"Error condition"
Searches for one or more errors that are detected in the decoded
data, see "Error Condition" on page 635.
Remote command:
SEARch:TRIGger:FLXRay[:SSOFrame] on page 1578
SEARch:TRIGger:FLXRay:SSYMbol on page 1578
SEARch:TRIGger:FLXRay:SIDData on page 1577
SEARch:TRIGger:FLXRay:SERRor on page 1577
Indicator bits
Searches for one or more indicator bits at the beginning of the header segment. Each
bit can be set to 0, 1, or X (do not care).
FlexRay (option R&S RTE-K4)