Protocol analysis
R&S
®
RTE
640User Manual 1326.1032.02 ─ 20
Specific settings for TDM audio signals are:
●
"Word length" on page 643
●
"Bit order" on page 643
●
"Channel offset" on page 643
●
"#TDM CHs" on page 643
●
"Frame offset" on page 643
●
"CH length" on page 643
Make sure that the tab of the correct serial bus is selected on the left side.
Audio Variant
Selects the protocol variant of the audio signal. The configuration possibilities exceed
the definitions of the standards.
Audio signals (option R&S
RTE-K5)
To Next Page
Loading...
