Protocol analysis
R&S
®
RTE
868User Manual 1326.1032.02 ─ 20
Make sure that:
●
In the [PROTOCOL] > "Decode" tab:
– The correct "Protocol" is selected.
– The data sources of the serial bus are channel signals.
●
In the "Trigger" > "Setup" tab:
– The trigger "Sequence" = "A only".
– The trigger "Source" = "Serial bus".
– The correct "Serial bus" is selected.
Type
Selects the trigger type for the SpaceWire analysis.
"Control frame"
Sets the trigger to the selected control type frame.
SpaceWire (option R&S RTE-K65)
To Next Page
Loading...
