Getting started
R&S
®
RTE
88User Manual 1326.1032.02 ─ 20
By default, the measurement of the high signal level is started.
3. Tap the "Automatic measurement" icon again. Then tap the waveform.
By default, the measurement of the low signal level is started.
4. Tap the "Automatic measurement" icon again. Then tap the waveform.
By default, the amplitude measurement is started.
5. Double-tap the results to open the "Measurements" dialog box.
In the "Setup" tab, you see the activated measurements and the assigned mea-
surement types.
6. In the "Meas1" line, tap the measurement type button labeled "High".
7. Select "Rise time".
8. In the "Meas2" line, tap the measurement type button labeled "Low".
9. Select "Fall time".
10. Under "Statistics", tap "Enable".
Trying out the instrument
To Next Page
Loading...
