Power analysis (option R&S RTE-K31)
R&S
®
RTE
960User Manual 1326.1032.02 ─ 20
Report Table
Shows a list of the available measurements.
After you select a Directory, you can manage previous report results from this direc-
tory. To add a measurement report press "Insert" or "Append". To remove a measure-
ment report press "Remove".
"DUT"
Shows the name of the DUT, see Chapter 16.1.1.2, "DUT",
on page 958.
"Date"
Shows the date of the measurement.
"Time"
Shows at what time, the measurement result was added to report.
"Comment"
Enters a comment.
"Add"
Adds the selected measurement to the report.
Remote command:
POWer:REPort:TEST:ADD on page 1948
POWer:REPort:TEST:COMMent on page 1950
POWer:REPort:TEST:COUNt on page 1950
POWer:REPort:TEST:INSert on page 1948
POWer:REPort:TEST:LSENd? on page 1951
POWer:REPort:TEST:REMove on page 1948
Selection
Manages the selection of the result reports.
Select all ← Selection
Selects all result reports.
Remote command:
POWer:REPort:TEST:SEA on page 1949
Deselect all ← Selection
Deselects all result reports.
Remote command:
POWer:REPort:TEST:DSEA on page 1949
Invert Selection ← Selection
Inverts the selection of all result reports, meaning that all selected result reports are
deselected and vice versa.
Remote command:
POWer:REPort:TEST:ISE on page 1949
Remove selected ← Selection
Removes the selected result report.
Remote command:
POWer:REPort:TEST:RSE on page 1949
Power measurement selection
To Next Page
Loading...
