Rohde & Schwarz RTE1104 - Page 1422

Remote control commands
R&S
®
RTE
1422User Manual 1326.1032.02 ─ 20
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<ShwThresLines> ON | OFF
*RST: OFF
Usage: Asynchronous command
BUS<m>:RESDetail
<ShwResDetails>
Shows detailed information for the frames.
The command is relevant for FlexRay, D-PHY, M-PHY, Ethernet, CXPI, and Custom
protocols.
Suffix:
<m>
.
1..4
Parameters:
<ShwResDetails> ON | OFF
*RST: ON
Usage: Asynchronous command
Firmware/software: FW 3.40
BUS<m>:FORMat <DataFormat>
Sets the number format for decoded data values of the indicated serial bus. It defines
the format in the decode table, and in the combs of the decoded signal on the screen.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<DataFormat> HEX | OCT | BIN | ASCII | ASCii | SIGN | USIG
ASCII = ASCii
USIG = unsigned
*RST: HEX
BUS<m>:NEWList <FileName>
Loads a label list file.
Suffix:
<m>
.
1..4
Selects the serial bus.
Setting parameters:
<FileName> String parameter with path and file name.
Protocols