Rohde & Schwarz RTE1104 - General; Waveform Generator (Option R&S RTE-B6); Waveform Generator Setup

Remote control commands
R&S
®
RTE
1923User Manual 1326.1032.02 ─ 20
18.19 Waveform generator (option R&S RTE-B6)
18.19.1 Waveform generator setup
18.19.1.1 General
WGENerator<m>:ACOPy..............................................................................................1923
WGENerator<m>[:ENABle]........................................................................................... 1923
WGENerator<m>:SOURce............................................................................................1923
WGENerator<m>:PRESet.............................................................................................1923
WGENerator<m>:ACOPy
Copies all settings from Gen1/Gen2 and applies them to Gen2/Gen1.
Suffix:
<m>
.
1..2
Usage: Event
WGENerator<m>[:ENABle] <State>
Enables the waveform generator and outputs the waveform.
Suffix:
<m>
.
1..2
Parameters:
<State> ON | OFF
Usage: Asynchronous command
WGENerator<m>:SOURce <OperationMode>
Sets the operation mode for the the waveform generator.
Suffix:
<m>
.
1..2
Parameters:
<OperationMode> FUNCgen | MODulation | SWEep | ARBGenerator
*RST: FUNCgen
WGENerator<m>:PRESet
Sets the parameters of the waveform generator to their default values.
Waveform generator (option R&S
RTE-B6)