Rohde & Schwarz RTE1104 - Peak Search Tab

Measurements
R&S
®
RTE
331User Manual 1326.1032.02 ─ 20
Remote command:
CURSor<m>:SIAD on page 1245
8.1.3.3 Peak search tab
Access: [CURSOR] key > "Peak Search" tab
The settings on this tab are only available in spectrum mode, i.e. the source of the cur-
sor measurement is an FFT math waveform. In this case, the cursors can indicate the
results of a peak search on the waveform. You can define which peaks the instrument
determines by defining the noise reject settings.
Cursor set (vertical tabs)
The settings for each cursor measurement (or cursor set) are configured on separate
tabs. For each cursor set, a horizontal pair of cursors, a vertical pair of cursors, or both
can be displayed.
c1, c2 absolute
Both cursors are set to the absolute peak value.
Remote command:
CURSor<m>:MAXimum[:PEAK] on page 1248
c2 next abs
Cursor 2 is set to the next smaller absolute peak from the current position.
Remote command:
CURSor<m>:MAXimum:NEXT on page 1248
c2 next left
Cursor 2 is set to the next peak to the left of the current position.
Remote command:
CURSor<m>:MAXimum:LEFT on page 1248
c2 next right
Cursor 2 is set to the next peak to the right of the current position.
Remote command:
CURSor<m>:MAXimum:RIGHt on page 1248
Cursor measurements