Rohde & Schwarz RTE1104 - Search on Decoded SENT Data; SENT Search Setup

Protocol analysis
R&S
®
RTE
759User Manual 1326.1032.02 ─ 20
For an introduction to zoom settings and setup, see:
●
Chapter 7.1.2, "Zoom settings", on page 280
●
Chapter 7.1.3, "Zooming for details", on page 284
Data format
You can select various data formats for the values displayed in the decode table and in
the combs of the decoded signal.
Remote command:
●
BUS<m>:FORMat on page 1422
Export of decode results
1. In the protocol decode table, press "Export".
The "Numeric Results" dialog opens.
For details, see Chapter 12.2.4, "Numeric Results", on page 492.
2. Select the decode results you want to export, the file format, and the delimiter.
3. Tap "Save" or "Save as".
Remote commands
Remote commands to retrieve decode results are described in Chapter 18.17.14.3,
"Decode results", on page 1712.
13.13.6 Search on decoded SENT data
Using the search functionality, you can find various events in the decoded data, the
same events which you also can trigger on. Before you can start the search, you have
to configure the bus correctly and acquire decoded data.
To search on decoded data, set the search "Source" to the serial bus that is configured
for the protocol to be analyzed.
See also Chapter 11, "Search functions", on page 445.
13.13.6.1 SENT search setup
Access: [SEARCH] > "Setup" tab
SENT (option R&S RTE-K10)