Getting started
R&S
®
RTE
92User Manual 1326.1032.02 ─ 20
3. To display the measurement results for the histogram, tap the "Measurement" icon
on the toolbar.
4. Tap the histogram.
The waveform count for the histogram is displayed.
5. To get more measurement results for the histogram, double-tap the results.
Alternatively, you can press the [MEAS] key on the front panel.
6. For "Meas 2", select "Category = Hist" and the required measurement type.
7. To finish the measurement, tap the "Close" icon in the result box.
8. To remove the histogram, tap the "Delete" icon on the toolbar and then the histo-
gram.
Both the histogram and any measurements based on that histogram are deactiva-
ted.
Trying out the instrument
To Next Page
Loading...
