Pulse source and TDR/TDT analysis (option R&S RTP-B7/K130)
R&S
®
RTP
1000User Manual 1337.9952.02 ─ 12
Enable
Activates the TDR/TDT measurements.
Use frequency response calibration
Disables the frequency response calibration. Without calibration, the measured signals
are only rescaled, and you can see the impact of the frequency response calibration on
the time domain waveform.
The setting is not available when measuring with default values.
Remote command:
TDRT:CALibration:USECaldata on page 2246
Averaging
The "Averaging" value is the "Average count (N-single count)", which you can also set
in the acquisition and trigger settings. See "Average count (N-single count)"
on page 149.
Increase the value to reduce noise.
Bandwidth
Sets the bandwidth of the DUT.
Remote command:
TDRT:BW on page 2246
TDR/TDT analysis (option R&S
RTP-K130)
To Next Page
Loading...
