Jitter analysis and clock data recovery
R&S
®
RTP
1016User Manual 1337.9952.02 ─ 12
Active Measurements
The "Active Measurements" list shows the measurements that are selected in the
selected category. At least, one measurement must be selected. If further settings are
available for a measurement, a settings icon is shown beside the measurement's
name.
To change the selection, tap "Add / Remove".
For details on the available measurements, see Chapter 18.1.1, "Jitter measurements",
on page 1013.
Remote command:
MEASurement<m>:MAIN on page 1364
MEASurement<m>:ADDitional on page 1365
18.1.2.2 Settings for clock measurements
The cycle-cycle measurements are intended to analyze the quality of clock signals.
They require a few additional settings for period and pulse width measurement. See
also: Table 18-1
► To configure a measurement, tap it in the "Active Measurements" list.
Jitter measurements (Option R&S
RTP-K12)
To Next Page
Loading...
