Rohde & Schwarz RTP Series - Page 1165

Remote control commands
R&S
®
RTP
1165User Manual 1337.9952.02 ─ 12
Advanced jitter analysis with option R&S RTP-K133: Jitter analy-
sis waveforms are automatically displayed in their own dia-
grams.
Advanced noise analysis with option R&S RTP-K134 : Noise
analysis waveforms are automatically displayed in their own dia-
grams.
<DiagramName> String with the name of the new diagram.
Example:
LAYout:ADD 'Diagram2',TAB,ON,C4W1,'MyDiagram3'
Creates a new diagram 'MyDiagram3' with waveform C4W1 in a
new tab that in front of 'Diagram2'.
Example: See Chapter 22.3.1.1, "Creating diagrams (SmartGrid)",
on page 1127.
Usage: Setting only
Asynchronous command
LAYout:REMove <DiagramName>
Closes the specified diagram. The waveforms are displayed as minimized waveforms
in their signal icons on the signal bar.
Setting parameters:
<DiagramName> String with the name of the diagram
Usage: Setting only
Asynchronous command
LAYout:SHOW <DiagramName>
Selects the specified diagram.
Setting parameters:
<DiagramName> String with the name of the diagram
Example: See Chapter 22.3.1.1, "Creating diagrams (SmartGrid)",
on page 1127.
Usage: Setting only
Asynchronous command
LAYout:SIGNal:ASSign <DiagramName>, <Source>
Shows the specified waveform in the selected diagram.
Instrument setup