Rohde & Schwarz RTP Series - Page 1175

Remote control commands
R&S
®
RTP
1175User Manual 1337.9952.02 ─ 12
RHOMbus
The intersections of the cursors with the waveforms are dis-
played by rhombus-shaped points.
*RST: LINes
Usage: Asynchronous command
DISPlay:RESultboxes:CUPosition <Position>
Defines the position of the cursor measurement results on the screen.
Parameters:
<Position> PREV | FLOA | DOCK
PREV
Preview: result icon on the signal bar.
FLOA
Floating result box in front of the diagrams.
DOCK
Docked: fixed tab below the diagrams.
*RST: DOCK
Usage: Asynchronous command
22.7.2.9 Measurement appearance
MEASurement<m>:DISPlay:GROuping <GroupResDialogs>
If ON, all measurement results are shown in one result box. If disabled, the results of
each measurement group are shown in a separate result box. The default position is
ignored.
Suffix:
<m>
.
1..10
The suffix is irrelevant. The setting affects all measurements
except for the peak list.
Parameters:
<GroupResDialogs> ON | OFF
*RST: ON
Usage: Asynchronous command
DISPlay:RESultboxes:MEPosition <Position>
Defines the position of the measurement results on the display.
Parameters:
<Position> PREV | FLOA | DOCK
PREV
Preview: result icon on the signal bar
Instrument setup