Remote control commands
R&S
®
RTP
1181User Manual 1337.9952.02 ─ 12
Usage: Event
Asynchronous command
22.7.3.2 Signal
DISPlay:INTensity <Intensity>
This value determines the strength of the waveform line in the diagram. Enter a per-
centage between 0 (not visible) and 100% (very strong).
The exact mapping of the cumulative value occurences according to the assigned color
table is guaranteed only if the intensity is set to 50% (default). All other intensity values
falsify the mapping but may improve the visibility of the signal.
Parameters:
<Intensity> Range: 0 to 100
Increment: 1
*RST: 50
Default unit: %
Usage: Asynchronous command
DISPlay:DIAGram:STYLe <Style>
Select the style in which the waveform is displayed.
Parameters:
<Style> VECTors | DOTS
VECTors
The individual data points are connected by a line.
DOTS
Only the individual data points are displayed.
*RST: VECTors
Usage: Asynchronous command
22.7.3.3 Clear results
DISPlay:CLR
Deletes all measurement results including long term measurement and statistics, all
waveforms, and the history.
Usage:
Event
Asynchronous command
Instrument setup
To Next Page
Loading...
