Rohde & Schwarz RTP Series - Page 1315

Remote control commands
R&S
®
RTP
1315User Manual 1337.9952.02 ─ 12
TRIGger<m>:EVENt:BEEP <Beep>
Generates a beep sound if the command is set to TRIGger.
Suffix:
<m>
.
1..3
The suffix is irrelevant.
Parameters:
<Beep> NOACtion | TRIGger
*RST: NOACtion
Usage: Asynchronous command
TRIGger<m>:EVENt:PRINt <Print>
Saves a screenshot at each trigger if the command is set to TRIGger.
For screenshot settings, see Chapter 22.16.9, "Screenshots", on page 1539.
Suffix:
<m>
.
1..3
The suffix is irrelevant.
Parameters:
<Print> NOACtion | TRIGger
*RST: NOACtion
Usage: Asynchronous command
TRIGger<m>:EVENt:WFMSave <SaveWfm>
Saves the waveform data to file at each trigger if the command is set to TRIGger.
For data export settings, see Chapter 22.16.5, "Waveform data export to file",
on page 1527.
Suffix:
<m>
.
1..3
The suffix is irrelevant.
Parameters:
<SaveWfm> NOACtion | TRIGger
*RST: NOACtion
Usage: Asynchronous command
TRIGger<m>:EVENt:RUNexec <RunExecutable>
Starts an external application if the command is set to TRIGger.
Use the following commands to set up the application:
●
EXECutable:NAME on page 1546
Trigger