Rohde & Schwarz RTP Series - Page 1320

Remote control commands
R&S
®
RTP
1320User Manual 1337.9952.02 ─ 12
LAYout:ZOOM:POSCoupling <DiagramName>, <ZoomName>, <PositionCoupl>
LAYout:ZOOM:POSCoupling? <DiagramName>, <ZoomName>
Enables or disables the position coupling of coupled zooms. If position coupling is
enabled and one zoom area is moved, the other coupled zoom areas are moved, too,
and keep their distance.
Parameters:
<PositionCoupl> ON | OFF
*RST: OFF
Parameters for setting and query:
<DiagramName> String with the name of the diagram on which the zoom is based
<ZoomName> String with the name of the zoom diagram
Usage: Asynchronous command
LAYout:ZOOM:HORZ:MODE
<DiagramName>, <ZoomName>,<Mode>
LAYout:ZOOM:HORZ:MODE? <DiagramName>, <ZoomName>
Defines whether absolute or relative values are used to specify the x-axis values.
Since the zoom area refers to the active signal, relative values ensure that the zoom
area remains the same.
Parameters:
<Mode> ABS | REL
Mode used to specify the x-axis values of the zoom area.
*RST: ABS
Parameters for setting and query:
<DiagramName> Name of the diagram on which the zoom area is based.
<ZoomName> Name of the zoom diagram
Example: See Chapter 22.3.1.2, "Creating zoom diagrams", on page 1127
Usage: Asynchronous command
LAYout:ZOOM:HORZ:ABSolute:POSition <DiagramName>,
<ZoomName>,<Position>
LAYout:ZOOM:HORZ:ABSolute:POSition? <DiagramName>, <ZoomName>
Defines the x-value of the centerpoint of the zoom area.
For numerical values, the input of a unit is not supported for this command.
Parameters:
<Position> Range: -100E+24 to 100E+24
Increment: 0.01
*RST: 0.01
Parameters for setting and query:
<DiagramName> Name of the diagram on which the zoom area is based.
Waveform analysis