Rohde & Schwarz RTP Series - Page 1333

Remote control commands
R&S
®
RTP
1333User Manual 1337.9952.02 ─ 12
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
REFCurve<m>:RESCale:HORizontal:FACTor <ScaleFactor>
A factor greater than 1 stretches the waveform horizontally, a factor lower than 1 com-
presses the curve.
Suffix:
<m>
.
1..4
Reference waveform
Parameters:
<ScaleFactor> Range: 1E-6 to 1E+6
Increment: 0.1
*RST: 1
Usage: Asynchronous command
REFCurve<m>:RESCale:HORizontal:OFFSet <Offset>
Moves the waveform horizontally. Positive values shift the waveform to the right, nega-
tive values shift it to the left.
Suffix:
<m>
.
1..4
Reference waveform
Parameters:
<Offset> Range: -100E+24 to 100E+24
Increment: 0.01
*RST: 0
Default unit: s
Usage: Asynchronous command
REFCurve<m>:RESCale:HORizontal:POSition <Offset>
Moves the waveform horizontally. Enter a value with a time unit suitable for the time
scale of the diagram. Positive values shift the waveform to the right, negative values
shift it to the left.
Suffix:
<m>
.
1..4
Parameters:
<Offset> Range: -100E+24 to 100E+24
Increment: 0.01
*RST: 0
Default unit: s
Waveform analysis