Remote control commands
R&S
®
RTP
1355User Manual 1337.9952.02 ─ 12
Parameters:
<YPosition2> Range: -50 to 50
Increment: 0.01
*RST: 0
Default unit: The unit depends on the type of the waveform.
Usage: Asynchronous command
CURSor<m>:YCOupling <Coupling>
Defines the positioning mode of the horizontal cursor. If the horizontal cursor lines track
the waveform, the y-coupling is irrelevant (CURSor<m>:MODE TRACk).
Suffix:
<m>
.
1..4
Selects the cursor set.
Parameters:
<Coupling> ON | OFF
ON
Moving one cursor line moves the other cursor line too. The cur-
sor lines always remain a fixed distance.
OFF
Each cursor line is positioned independently.
*RST: OFF
Usage: Asynchronous command
CURSor<m>:X1ENvelope <EnvelopeCurve1>
If the waveform arithmetics are set to envelope curve (see CHANnel<m>[:
WAVeform<n>]:ARIThmetics on page 1196) and CURSor<m>:TRACking[:
STATe] is set to "ON", this setting defines how the first horizontal cursor is positioned.
Suffix:
<m>
.
1..*
Selects the cursor set. 4 cursor sets are available.
Parameters:
<EnvelopeCurve1> MIN | MAX
MIN
The horizontal cursor is set to the crossing point of the vertical
cursor with the minimum waveform envelope.
MAX
The horizontal cursor is set to the crossing point of the vertical
cursor with the maximum waveform envelope.
*RST: MIN
Usage: Asynchronous command
Cursor measurements
To Next Page
Loading...
