Rohde & Schwarz RTP Series - Page 1363

Remote control commands
R&S
®
RTP
1363User Manual 1337.9952.02 ─ 12
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
Parameters:
<Source2> Second source of the measurement, see MEASurement<m>:
SOURce on page 1361.
Digital channels are only available if a digital channel is set as
first measurement source using MEASurement<m>:FSRC.
*RST: C2W1
Usage: Asynchronous command
MEASurement<m>:CATegory <Category>
Defines the measurement category.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
Parameters:
<Category> AMPTime | JITTer | EYEJitter | SPECtrum | HISTogram |
PROTocol
AMPTime
Amplitude and time measurements
JITTer
Jitter measurements, available if one of the jitter options is
installed
EYEJitter
Eye diagram mesurements
SPECtrum
Spectrum measurements
HISTogram
Histogram measurements
PROTocol
Protocol measurements
*RST:
AMPTime
Example: See "Creating and reading histograms" on page 1130
Usage: Asynchronous command
Automatic measurements