Rohde & Schwarz RTP Series - Page 1384

Remote control commands
R&S
®
RTP
1384User Manual 1337.9952.02 ─ 12
Usage: Asynchronous command
MEASurement<m>:AMPTime:ARIThmetic:PARameter<n>:SPECtrum
<ArithOp1MeasSpectrum>
Selects the spectrum arithmetics measurements for the measurment group.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
<n> 1..2
Selects the operand.
Parameters:
<Op1MeasSpectrum>CPOWer | ACPower | OBWidth | SBWidth | TOI | AMMod |
THD | THDPCT | THDPct | THDA | THDU | THDR | PLISt |
HAR | THDF | SPAR
*RST: CPOWer
Usage: Asynchronous command
MEASurement<m>:AMPTime:ARIThmetic:PARameter<n>:TYPE <ArithOp2Type>
Sets the type of amplitude arithmetic measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
<n> 2
Parameters:
<ArithOp2Type> MEASurement | CONStant
MEASurement
Performs an arithmetic operation between two measurement
results.
CONStant
Performs an operation between a measurement result and a
user defined fixed constant.
*RST: MEASurement
Usage: Asynchronous command
MEASurement<m>:SPECtrum:ARIThmetic:CONStant <ArithConstant>
Sets a constant numeric value as the second operand of the spectrum arithmetic mea-
surement.
Automatic measurements