Rohde & Schwarz RTP Series - Page 1457

Remote control commands
R&S
®
RTP
1457User Manual 1337.9952.02 ─ 12
CALCulate:MATH<m>:FFT:SPECtrogram:CMODe.......................................................... 1457
CALCulate:MATH<m>:FFT:USEColtab...........................................................................1457
CALCulate:MATH<m>:FFT:SPECtrogram:STATe.............................................................1457
CALCulate:MATH<m>:FFT:SPECtrogram:TIMeline<n>:POSition...................................... 1458
CALCulate:MATH<m>:FFT:SPECtrogram:TIMeline<n>:STATe..........................................1458
CALCulate:MATH<m>:FFT:SPECtrogram:CMODe <ColorTableMode>
Selects the color table mode for the frequency analysis display.
Suffix:
<m>
.
1..8
Parameters:
<ColorTableMode> INCI | AMPL
INCI
("Incidence") The display color is set depending on the fre-
quency of occurrence of a value.
AMPL
("Amplitude") In the spectrogram and the frequency analysis dis-
play, the color is used to indicate the magnitude of the FFT sig-
nal. The higher the amplitude the higher the color in the
assigned color table.
*RST: INCI
Usage: Asynchronous command
CALCulate:MATH<m>:FFT:USEColtab <UseColorTable>
If enabled, the selected waveform is displayed according to its assigned color table.
For information on the available color tables, see Chapter 4.3.2, "Color tables",
on page 98.
If this option is disabled, the preset color of the selected channel source is displayed,
and the intensity of the specific signal color varies according to the cumulative occur-
rence of the values.
Suffix:
<m>
.
1..8
Parameters:
<UseColorTable> ON | OFF
*RST: OFF
Usage: Asynchronous command
CALCulate:MATH<m>:FFT:SPECtrogram:STATe <State>
Enables the spectrogram display for a math waveform.
Suffix:
<m>
.
1..8
Spectrum analysis