Rohde & Schwarz RTP Series - Page 1466

Remote control commands
R&S
®
RTP
1466User Manual 1337.9952.02 ─ 12
Example: See Chapter 22.3.3.1, "Creating a user mask", on page 1132
Usage: Asynchronous command
MTESt:SEGMent:POINt:ADD <MaskTestName>, <MaskSegmIdx>
Adds a new point to the segment definition.
Setting parameters:
<MaskTestName> String with the name of the mask test
<MaskSegmIdx> Number of the segment. Counting starts from 0.
Example: See Chapter 22.3.3.1, "Creating a user mask", on page 1132
Usage: Setting only
Asynchronous command
MTESt:SEGMent:POINt:INSert <MaskTestName>, <MaskSegmIdx>,
<MaskSegmPtIdx>
Inserts a new point before the specified mask segment point.
Setting parameters:
<MaskTestName> String with the name of the mask test
<MaskSegmIdx> Number of the segment. Counting starts from 0.
<MaskSegmPtIdx> Number of the point. Counting starts from 0.
Usage: Setting only
Asynchronous command
MTESt:SEGMent:POINt:REMove <MaskTestName>, <MaskSegmIdx>,
<MaskSegmPtIdx>
Removes the specified point from the mask segment.
Setting parameters:
<MaskTestName> String with the name of the mask test
<MaskSegmIdx> Number of the segment. Counting starts from 0.
<MaskSegmPtIdx> Number of the point. Counting starts from 0.
Usage: Setting only
Asynchronous command
MTESt:SEGMent:POINt:COUNt? <MaskTestName>, <MaskSegmIdx>
Returns the number of defined points for the specified mask segment.
Query parameters:
<MaskTestName> String with the name of the mask test
Mask testing