Rohde & Schwarz RTP Series - Page 1717

Remote control commands
R&S
®
RTP
1717User Manual 1337.9952.02 ─ 12
Parameters:
<MinGapBits> Range: 0 to 100
Increment: 1
*RST: 4
Default unit: bit
TRIGger<m>:ARINc:MAXGap:SELect <MaxGapSelect>
Enables triggering when the maximum gap is out of range. You can set the maximum
gap with: TRIGger<m>:ARINc:MAXGap:BITS.
Parameters:
<MaxGapSelect> ON | OFF
*RST: OFF
TRIGger<m>:ARINc:MAXGap:BITS
<MaxGapBits>
Sets the value for the maximum gap to be triggered on.
Parameters:
<MaxGapBits> Range: 0 to 1000
Increment: 1
*RST: 100
Default unit: bit
TRIGger<m>:ARINc:SDI <SDI>
Sets the source/destination identifier (SDI) bits.
Parameters:
<SDI>
TRIGger<m>:ARINc:SSM <SSM>
Sets the sign/status matrix (SSM) bits.
Parameters:
<SSM>
22.17.9.3 Decode results
To load and acivate a label list, use:
●
BUS<m>:NEWList on page 1550
●
BUS<m>:SYMBols on page 1550
BUS<m>:ARINc:WCOunt?............................................................................................1718
BUS<m>:ARINc:WORD<n>:DATA?............................................................................... 1718
BUS<m>:ARINc:WORD<n>:LABel?...............................................................................1718
BUS<m>:ARINc:WORD<n>:PATTern?........................................................................... 1719
Protocols