Acquisition and waveform setup
R&S
®
RTP
176User Manual 1337.9952.02 ─ 12
AC Coupling
Enables AC coupling in the R&S RT-ZPR power rail probes, which removes DC and
very low-frequency components. The R&S RT-ZPR probe requires 50 Ω input termina-
tion, for which the channel AC coupling is not available. The probe setting allows AC
coupling also at 50 Ω inputs.
Remote command:
PROBe<m>:SETup:ACCoupling on page 1216
Copy to offset
Sets the measured ProbeMeter value as offset. Thus, the value is considered in mea-
surements.
Remote command:
PROBe<m>:SETup:ADVanced:PMToffset on page 1216
5.6.4.4 R&S RT-ZHD high-voltage differential probes
Figure 5-11: Probe setup for R&S
RT-ZHD probes
The offset is the differential offset. See "Offset" on page 160.
Specific settings for R&S RT-ZHD probes are the following:
Probes
To Next Page
Loading...
