Rohde & Schwarz RTP Series - Page 1782

Remote control commands
R&S
®
RTP
1782User Manual 1337.9952.02 ─ 12
Parameters:
<SignalType> DIFFerential | SINGle
*RST: DIFFerential
BUS<m>:TBTO:RDAM <SrcRevDAminus>
Selects the DA- source of the provided reversed single ended signal, if BUS<m>:
TBTO:RTYP is set to SINGle.
Suffix:
<m>
.
1..4
Parameters:
<SrcRevDAminus> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4
BUS<m>:TBTO:RDAP <SourceRevDAplus>
Selects the DA+ source of the provided reversed single ended signal, if BUS<m>:
TBTO:RTYP is set to SINGle.
Suffix:
<m>
.
1..4
Parameters:
<SourceRevDAplus> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4
BUS<m>:TBTO:RDIF <SrcRevDiff>
Sets the source of the provided reversed differential signal, if BUS<m>:TBTO:RTYP is
set to DIFFerential.
Suffix:
<m>
.
1..4
Parameters:
<SrcRevDiff> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4
BUS<m>:TBTO:RTYP <SignalRevType>
Sets the type of reverse signal measurement.
Suffix:
<m>
.
1..4
Parameters:
<SignalRevType> DISabled | DIFFerential | SINGle
*RST: DISabled
Protocols